How To Load A String A Ryobi SS30

The Ryobi SS30 is powered by a 2-cycle gasoline engine. The SS30 makes use of small diameter nylon trimmer string fitted to chopping grass and weeds in areas round a garden or panorama. The nylon trimmer string turns into worn and frayed over time with regular use. Changing the string includes eradicating the road spool from the trimmer head so to set up new string.

Step 1
Take away the spark plug wire from the spark plug on the SS30 engine to stop unintended beginning whereas changing the trimmer string.

Step 2
Grasp the trimmer head with one hand and the spool with the opposite. Flip the spool clockwise and pull straight out to free the spool from the trimmer head. Maintain the spring on the again of the spool in place and notice how it’s positioned on the spool.

Step 3
Take away any previous trimmer string from the spool and discard it.

Step 4
Reduce two 9-foot lengths of .095-inch diameter trimmer string from a filler spool with scissors.

Step 5
Insert the top of 1 9-foot size of string into the retaining gap within the higher a part of the spool. Wrap the string counterclockwise till 6-inches of string extends from the spool. Safe the string within the retaining clip on the aspect of the spool.

Step 6
Set up the second 9-foot size of string on the decrease half of the spool. Insert the top of the road into the retaining gap and wrap counterclockwise across the spool. Safe the final 6 inches within the clip on the aspect of the spool.

Step 7
Place the spring on the again of the spool and feed the extending ends of the trimmer line by the holes within the trimmer head. Insert the spool into the trimmer head and switch to the left to safe. Pull the ends of each strains on the similar time to free them from the clips in preparation to be used. Reconnect the spark plug wire to the spark plug to be used.

Leave a Reply

Your email address will not be published. Required fields are marked *